9-3 Arc/Aero (9440) L4-2.0L Turbo (2.0 T) (2004)
Figure 2
3.
Remove the screws from the handle.
4.
Lift the door trim up so that the hooks detach from the door. Use 82 93 474 Removal tool to detach the guide pin at the rear edge of the trim.
5.
Check whether the correct wiring harness is fitted as follows:
5.A. Turn the ignition key to the ON position.
5.B. Close the drivers door.
5.C. Connect the new switch to the central locking system connector.