9-3 Arc/Aero (9440) L4-2.0L Turbo (2.0 T) (2004)
/l4-2.0l_turbo_(2.0_t)/Page-2142002.png)
9. Remove the electronic unit by twisting out.
NOTE: Ensure that the bolts come with it. Remove the gasket from the hydraulic unit if it does not follow the control module.
To fit
1. Check that the gasket sits correctly on the new control module.
2. Fit the inner bottom rear screw and fit the control module to the assembly.
Fit the bolts.
Tightening torque 2.5 Nm (1.8 lbf ft)
NOTE: Tighten the bolt alternately.
3. Put the assembly in place with the guide pin in the rubber bushing. Make sure the brake pipes are secured in the clips on the MacPherson strut
tower.
