9-3 Arc/Aero (9440) L4-2.0L Turbo (2.0 T) (2004)
/l4-2.0l_turbo_(2.0_t)/Page-2229001.png)
Brake Master Cylinder: Service and Repair
Master cylinder
To remove
1. Place wing covers on the front wings.
2. Raise the car.
3. Connect the brake bleeder to the air nipple on the front left wheel.
4. Open the nipple and suction out the brake fluid until one of the reservoir chambers is empty.
5. Disconnect the brake bleeder and close the nipple.
6. Connect the brake bleeder to the air nipple on the right front wheel.
7. Open the nipple and suction out the brake fluid until one of the reservoir chambers is empty.
8. Disconnect the brake bleeder and close the nipple.
9. Manual gearbox: Connect the brake bleeder to the clutch bleed nipple.
10. Manual gearbox: Open the nipple and suction out oil until the level in the reservoir falls below the connection.
11. Manual gearbox: Disconnect the brake bleeder and close the nipple.
