9-3 Convertible (9400) L4-2.0L Turbo (2.0 HOT) (2003)
12. Hook the ends of the wire onto the eye of the screwdriver and bend over the ends so they will not slide off.
13. Pull the screwdriver back through the adhesive into the cabin. Pull in the wires about 0.7 m.
14. Unhook the cutting wire from the screwdriver. Straighten the ends of the wire to an oblique angle. Remove the screwdriver from the car.
15. Place the wire under the moulding. Poke it in using the plastic tool that came with the kit. Make sure the cutting wire is around all the corners. Pull
in the wires and check their position.