9-3 Convertible (9400) L4-2.0L Turbo (2.0 HOT) (2003)
/l4-2.0l_turbo_(2.0_hot)/Page-2062014.png)
Figure 10
7.
Press the adjusting housing to its front position while drilling a 3 mm hole straight through the housing and fit screw 79 63 937 (long screw). Blow
clean from drilling filings inside the handbrake lever.
Note
Fit a piece of metal plate between the handbrake lever and the compartment inside the lever so that the drill bit does not enter the compartment.
8.
Lower the lever to its lowest position and then raise it three notches. Press the gear segment backwards as far as possible using a large screwdriver.
Tap carefully with a hammer on the screwdriver to ensure that the gear segment reaches its rearmost position.
