9-3 Convertible (9400) L4-2.0L Turbo (2.0 HOT) (2003)
/l4-2.0l_turbo_(2.0_hot)/Page-2448002.png)
8. Remove the high-pressure pipe from the holder on the wheel housing.
9. Remove the high-pressure pipe from the bulkhead bracket.
10. Remove the bolt in the PAD-connection by the receiver dryer.
11. Plug the openings.
12. Move aside the high-pressure pipe.
13. Remove the high-pressure pipe from the PAD-connection by the lead-through in the bulkhead.
14. Plug the openings.
15. Cut the pipe as shown in the illustration. Remove the pipe sections by lifting them up.
Fitting
1. Fill with compressor oil.
2. Fit the rear section of the high-pressure pipe from above.
