9-3 Convertible (9400) L4-2.0L Turbo (2.0 HOT) (2003)
/l4-2.0l_turbo_(2.0_hot)/Page-14002.png)
5. After replacement of the TWICE control module, it must be programmed into the car.
Programming
NOTE: All keys to the car must be programmed at the same time.
IMPORTANT: The transponders and remote controls that are not available during programming will be rendered unusable.
1. Connect the diagnostic tool.
2. Remove the antenna unit for immobilisation by turning it clockwise. Do not unplug the contact. Place the antenna to the side of the ignition switch.
NOTE: The antenna unit should not be removed in low temperatures as cracks may form.
3. Hold the included transponder above the hole in the antenna unit. Turn the ignition to the ON position. Hold the transponder in the same position
for a few seconds.
When the alarm indicator diode stops flashing, the transponder code has been read by TWICE. If the alarm indicator diode does not stop double
flashing, repeat step 3. Adjust the position of the included transponder.
