9-3 Convertible (9400) L4-2.0L Turbo (2.0 HOT) (2003)
/l4-2.0l_turbo_(2.0_hot)/Page-2297008.png)
15. Remove the tape securing the steering wheel and fit the steering shaft to the pinion shaft. Tighten the lock bolt.
Tightening torque: 24 Nm (18 ft. lbs.)
Warning: If the steering wheel position has been altered, the coil spring must be adjusted.
For adjusting the contact roller, refer to Restraint Systems, Air Bag Systems for procedures to fit for the contact roller.
16. Fit the lower dashboard panel including the data link connector on the driver's side.
17. Lower the car and turn the wheels to point straight ahead.
18. Fill the hydraulic fluid reservoir with the specified fluid. Start the engine, turn the steering wheel to the right and left lock positions 2 - 3 times.
Turn off the engine and correct the fluid level. At 20 C, it should be in between the MAX and MIN markings on the dipstick in the hydraulic fluid
reservoir.
19. Check for leaks at the control valve couplings.
20. Make sure the steering wheel is positioned "straight ahead" when the car is steering straight ahead on a level road.
