9-3 Convertible (9400) L4-2.0L Turbo (2.0 HOT) (2003)
/l4-2.0l_turbo_(2.0_hot)/Page-1847002.png)
Important: Do not damage the sealing surface on the selector rod.
In-car fitting
1. Clean the selector rod and check that it has no burrs.
2. Wind a layer of thin, smooth plastic tape around the hole in the selector rod.
3. Grease the sealing ring and fit the seal on the selector shaft. Remove the tape and tap in the seal using 87 90 685 Fitting tool, sealing ring selector
shaft and 87 91 709 Clamp. Tap only until the seal is level with the clutch housing.
4. Join the selector rods using the M8 screw.
5. Check the oil level in the gearbox and top up as needed. Use 87 92 590 Tool oil level plug.
