9-3 Convertible (9400) L4-2.0L Turbo (B205) (2000)
Shock Sensor: Service and Repair
To remove
NOTE: The glass breakage sensor is not stocked separately as a spare part. The complete lens cover must be replaced.
1
Release the lens cover on the centre roof light.
2
Loosen the switch panel on the root lamp by pressing it forwards and at the same time pulling the rear edge downwards.
3
Release the electrical connector from the sensor and lift off the lens cover.
To fit
1
Replace the connector. Ensure that the connector is properly seated and attached to avoid vibrations.
2
Fir the switch panel. Start with the front edge and push it forwards. Then press the rear edge upwards.
3
Fit the lens cover.