9-3 Convertible (9400) L4-2.0L Turbo (B205) (2000)
Convertible Top Hydraulic Control Unit: Procedures
Hydraulic Unit
Removing
1
Raise (close) the soft top to a position with the soft top cover raised and the fifth bow lowered (horizontal).
2
Fold forward the rear backrest.
3
Remove the cover over the hydraulic unit.
4
Remove the hydraulic unit retaining bolts.
5
Lift up the hydraulic unit. Check the oil level in the oil reservoir.
IMPORTANT
Lift up the hydraulic unit carefully so that the hydraulic hoses are not damaged.
6
Lay out paper under the hydraulic unit to catch any oil spills.
7
Unplug the connectors.
8
Mark the hoses and remove the retaining bolts by the hose connections.
9
Remove the cable ties holding the hoses.
Lift out the hydraulic unit.
Fitting
1
Check the hose markings and connect the hoses to the pump and tighten the bolts.
2
Fit the cable ties.
3
Plug in the connectors.
4
Fill oil in the reservoir.
Use oil part No. (16) 30 32 356.
IMPORTANT