9-3 Convertible (9400) L4-2.0L Turbo (B205) (2000)
1
Remove the rear side trim. See "Body - Convertible - Adjustment/replacement - Rear side trim".
2
Remove the clip for the rear trim and lift up the trim.
3
Remove the screws holding the microswitch.
4
Unplug the connector, remove the microswitch and remove the tape holding the wires.
5
Run the cable through the bracket for the backrest catch mechanism and fit the microswitch. Torque specification: 1.6 in.lbs.
NOTE:
It is important to not overtighten the screws. Over-tightening can cause internal damage to the switch.
6
Plug in the connector.