9-3 Convertible (9400) L4-2.0L Turbo (B205) (2000)
-
Turn the ignition switch to the ON position.
-
Connect test lamp 86 11 857 to the upper pin of the fuse holder and a good grounding point.
-
The test lamp should light.
Checking The Wiring Harness
Jiggle the leads and in-line connectors at several places and in different directions to reveal intermittent breaks and short circuits in the wiring harness.
Observe the multimeter test lamp or diagnostic tool while doing this.
Is the function correct?
NO
-
See: Automatic Transmission/Rectifying the Lead - XIII
YES -
See: Automatic Transmission/Checking the Fuse - III
Check CANCEL Function
Check CANCEL Function
Information
System is now in diagnosis mode.
-
Release CANCEL button.
CRUISE lamp should go out.
Is the function correct?
NO
-
See: Automatic Transmission/Checking the Control Module's Switch Input - I
YES -
See: Automatic Transmission/Check SET Function
Checking the Lead From Switch to Control Module - I
Checking the Lead From Switch to Control Module