9-3 Coupe (9400) L4-2.0L Turbo (B204) (1999)
13
Disconnect the electrical connector from the tilt sensor.
To fit
1
Fit the connector to the lilt sensor.
2
Fit the sensor on its holder.
3
Fit the floor duct in position.
4
Fit the floor console in position.
5
Fit the switch.
6
Fit the remote control receiver.
7
Fit the connector on the receiver.
8
Screw the floor console in position with the 2 screws and 2 nuts.
9
Fit the rear section of the floor console.
10
Fit the ignition switch cover.
11
Fit the antenna unit.