9-3 Coupe (9400) L4-2.0L Turbo (B204) (1999)
/l4-2.0l_turbo_(b204)/Page-2967004.png)
5. Install the floor air duct.
6. Install knee shields.
7. Install the side panel, 1 screw.
8. Fit the connector of the glove-box lighting.
9. Put the glove box back into place.
10. Switch the ignition on and check the SRS system and control module with the diagnostic tool as follows:
Connect the diagnostic tool to the diagnostic socket under the dashboard. Clear any diagnostic trouble codes that are present.
Turn the ignition off and on again. Wait at least 10 seconds with the ignition on.
Check whether a diagnostic trouble code is shown:
If a diagnostic trouble code is shown:
Carry out the relevant fault diagnosis as described under the respective DTC.
If no diagnostic trouble code is shown:
The installation is successful. Disconnect the diagnostic tool.
