9-3 Coupe (9400) L4-2.0L Turbo (B204) (1999)
/l4-2.0l_turbo_(b204)/Page-3035003.png)
1
Fit the side airbag, 3 nuts.
Tightening torque 6.5 Nm (4.8 lbf ft)
2
Fit the SAHR system's resistance spring as the mirror image of the spring on the other side.
3
Attach the felt cover to the hook in the Pullmaflex net.
4
Secure the two wire rods that hold the front cover at the bottom rear edge.
5
Secure the rear part of the backrest cover by fitting the cover battens along the edge on the rear of the backrest frame.
6
Fit the rear part of the backrest cover by fixing the cover battens along the sides.
Install the adjustment mechanism of the lumbar support.
7
Slide the stiffener board into its proper position.
8
Run the connecting cable of the side airbag through the hole in the backrest cover and plug it into the 29-pin connector under the seat.
9
Fix the cover batten at the lower edge
10
Fix the backrest cover at the lower edge by fitting the cord(s) on the underside.
11
Lift the seat into the car.
