9-3 Coupe (9400) L4-2.0L Turbo (B205) (2001)
To fit
NOTE: Fitting of a new bonnet-release cable is facilitated by a pull-through, consisting of a thin steel wire with a loop at the end, that is either pushed
through the bulkhead or pulled through the bulkhead with the cable to be replaced.
1. Pull the pull-through cable through the bulkhead and hook the bonnet-release cable to the loop.
NOTE: Secure with tape and lubricate the cable with vaseline to facilitate fitting of the cable.
2. Pull the bonnet-release cable through the bulkhead. Push the cable at the same time as it is pulled.
3. Press the release-lever housing into position.
4. Fit the fuse holder with the two retainer bolts.
5. Fit the DICE module as follows:
-
Fit the DICE module and the relay holder.
-
Fit the air distribution ducts.
-
Fit the lower section of the instrument panel.
6. Pull the bonnet-release cable to the radiator member via the lead-through in the bottom of the washer fluid reservoir filler opening.