9-3 Coupe (9400) L4-2.0L Turbo (B205) (2001)
1. Fit the solenoid.
2. Screw in the upper screw.
3. Tighten the lower screw (it can be difficult to reach) using a magnetic T15 bit.
4. Spray the connector with Kontakt 61 (part no.30 04 520). Plug in the connector and fit the rubber seal.
IMPORTANT
When the limp home solenoid is removed, the throttle body will go into mechanical limp-home mode. Therefore, after fitting, the limp-home mechanism
must be reset. See "Resetting activated Limp Home solenoid"
5. Fit the cover on the throttle body pedal arm.
6. Put the engine cover in place.