9-3 Hatchback (9400) L4-2.0L Turbo (B205) (2000)
7
Fold down the front of the carpet.
8
Remove the release lever housing by removing the lock tabs with two small screwdrivers, one from above and the other from below, pulling
rearwards and outwards.
9
Pull out the bonnet-release cable along with the release lever housing (one unit) through the bulkhead.
To fit
NOTE: Fitting of a new bonnet-release cable is facilitated by a pull-through, consisting of a thin steel wire with a loop at the end, that is either pushed
through the bulkhead or pulled through the bulkhead with the cable to be replaced.
1
Pull the pull-through cable through the bulkhead and hook the bonnet-release cable to the loop.
NOTE: Secure with tape and lubricate the cable with vaseline to facilitate fitting of the cable.
2
Pull the bonnet-release cable through the bulkhead. Push the cable at the same time as it is pulled.
3
Press the release-lever housing into position.
4
Fit the fuse holder with the two retainer bolts.
5
Fit the DICE module as follows:
-
Fit the DICE module and the relay holder.
-
Fit the air distribution ducts.
-
Fit the lower section of the instrument panel.
6
Pull the bonnet-release cable to the radiator member via the lead-through in the bottom of the washer fluid reservoir filler opening.