9-3 Hatchback (9400) L4-2.0L Turbo (B205) (2000)
2
Select "(FO): Diagnostics" from the main menu.
3
Select "Model Year" and "Vehicle Type".
4
Select "(F2): Body" from the menu.
5
Select "TWICE" (Theft Warning Central Electronics).
6
Start programming of the immobilizer by selecting "(F2) Immobilization" from the menu.
7
Select "Trionic" (1999) or "Trionic 7" (2000).
8
Follow the instructions on Tech 2. The procedure is complete when the message "Immobilizer code programmed" is displayed.
9
Erase any diagnostic trouble codes. Fuse 28 may need to be removed and refitted for communication with Tech 2 to be possible.
Check and Resetting
1
Switch off Tech 2 and turn the ignition OFF.
2
Start the engine.
3
If the engine does not start, turn the ignition key to OFF, then remove and refit fuse 28 (engine control module).
4
Start the engine. Depress the accelerator and then check if any new diagnostic trouble codes have been generated. Rectify and erase any diagnostic
trouble codes.
5
Turn the ignition OFF and wait 10 seconds. Check that the throttle is not in limp-home mode as follows:
a
Remove the upper engine cover.
b
Remove the cover from the throttle body.
c
Turn the pedal arm clockwise.
d
Check that the throttle arm does not make the reciprocal movement when the pedal arm is turned.
e
To reset limp-home mode, if necessary, see WIS - Engine - Trionic T7 - Adjustments/replacement - Resetting triggered limp-home solenoid.
f
Fit the cover over the throttle body and the upper engine cover.
Marking the Campaign Plate
After the car has been inspected and/or modified, mark the campaign plate in box C4, using a numeral "8" (Saab Special Tool P/N 02 97 713). If needed,
order this special tool directly from Kent-Moore at 1-800-345-2233.