saab Workshop Repair Guides

Saab Workshop Service and Repair Manuals

Wheel Speed Sensor|Service and Repair > < Front-Wheel Sensor|Page 6775
Page 1
background image

Wheel Speed Sensor: Description and Operation
Rear-Wheel Sensors

Rear-wheel sensors

The rear left (RL) wheel sensor sends a wheel-speed signal to pin 9 on the control module. The sensor is grounded via pin 8.
The rear right (RR) wheel sensor sends a wheel-speed signal to pin 2 on the control module. The sensor is grounded via pin 1.
The wheel sensors are integrated into the wheel hubs and consist of an inductive sensor with 29 teeth.
The inductive sensor works somewhat like a miniature alternator, the sinusoidal voltage of which increases with increasing wheel speed. The
sinusoidal voltage alternates between positive and negative polarity, which is achieved through the alternating teeth and gaps on the toothed wheel. By
measuring the frequency, the control module can determine the speed of the wheel in question.
A wheel speed of 20 km/h gives about 0.8 VAC, 70 Hz. 
The rear wheel sensor is of different design to the front wheel sensors and is not as sensitive to wheel bearing play.
The ABS control module uses wheel speed information for:
^

calculating wheel acceleration, wheel retardation and the car's reference speed, which is normally measured on the fastest rear wheel;

^

comparing the speeds of the rear wheels to determine whether the car is being driven straight ahead or cornering;

^

calculating wheelspin on retardation and, if the limit is exceeded, activating the ABS function.

Diagnosis

In the event of an RL open circuit, diagnostic trouble code C1382 will be generated, the ABS lamp will come on and the ABS function will be
disabled.
In the event of a mechanical fault or malfunction RL, DTC C1381 will be generated, the ABS warning lamp will come on and the ABS system will be
disabled.
If there is a break in the rear right (RR) circuit, DTC C1387 will be generated, the ABS warning lamp will come on and the ABS system will be
disabled.
In the event of a mechanical fault or malfunction RR, DTC C1386 will be generated, the ABS warning lamp will come on and the ABS system will be
disabled.

Wheel Speed Sensor|Service and Repair > < Front-Wheel Sensor|Page 6775