9-3 SE Hatchback (9400) L4-2.0L Turbo (B205) HO (2000)
/l4-2.0l_turbo_(b205)_ho/Page-3087050.png)
-
Switch off the engine.
-
Turn the ignition switch to the ON position.
-
Connect test lamp 86 11 857 to the upper pin of the fuse holder and a good grounding point.
-
The test lamp should light.
Checking The Wiring Harness
Jiggle the leads and in-line connectors at several places and in different directions to reveal intermittent breaks and short circuits in the wiring harness.
Observe the multimeter test lamp or diagnostic tool while doing this.
Is the function correct?
NO
-
See: Manual Gearbox/Checking the Fault Symptoms/Lamp Does Not Go on/Rectifying the Lead - III
YES -
See: Manual Gearbox/Checking the Fault Symptoms/Lamp Does Not Go on/Checking the Fuse
Checking the Control Module's Sensor Input
Checking Control Module's Sensor Input
-
Turn the ignition switch to the ON position.
-
Connect BOB (Break Out Box) between CRUISE control module and CRUISE control module female connector.
