9-3 SE Hatchback (9400) L4-2.0L Turbo (B205) HO (2000)
/l4-2.0l_turbo_(b205)_ho/Page-1284002.png)
11. Lift up the throttle body, clamp and detach the 2 coolant hoses to the throttle body and detach the hose under the limp-home solenoid.
12. Detach the lower vacuum hose.
To fit
IMPORTANT When the ignition is turned on and the solenoid/throttle body has been removed, the limp-home solenoid will be activated. After
ignition ON the limp-home mechanism must be reset in accordance with "Resetting triggered limp-home solenoid"
1. Fit the lower vacuum hose.
2. Fit the coolant hoses and remove the clamps.
3. Position the throttle body and screw it on with the 3 retaining screws. Fit a new seal if necessary and lubricate it with a thin coat of Vaseline (part
no.30 20 271).
4. Attach the hose under the limp-home solenoid and fit the clip.
5. Tighten the 3 throttle body retaining screws.
6. Spray the throttle body 10-pin connector with Kontakt 61 (part no.30 04 520) and plug it in.
7. Spray the limp-home solenoid connector with Kontakt 61 (part no.30 04 520). Plug in the connector and fit the rubber seal.
8. Fasten the accelerator pedal wire to the throttle body pedal arm.
