9-3 SE Sedan (9400) L4-2.0L Turbo (B204) HO (1999)
Tow Sensor: Service and Repair
To remove
1
Remove the antenna unit by turning it clockwise. Lift the unit up and disconnect the electrical connector.
2
Remove the ignition switch cover. Start at the back as it is fastened with hooks at the front.
3
Unscrew 2 screws holding the floor console.
4
Remove the rear section of the floor console.
5
Unscrew 2 nuts holding the floor console.
6
Remove the switch. Bend at the front edge.
7
On the Cabriolet, remove the interior lighting switch.
8
Loosen the remote control receiver from the side wall of the floor console.
9
Disconnect the electrical connector from the receiver unit.
10
Lift off the floor console.
11
Lift the floor duct.
12
Remove the tilt sensor from its holder (slides off).