9-3 SE Sedan (9400) L4-2.0L Turbo (B204) HO (1999)
Center Mounted Brake Lamp: Service and Repair
To remove
1
Remove the strip above the rear window (inside the car).
2
Remove the two rubber plugs.
3
Unscrew the nuts holding the brake light.
4
Separate the connector.
5
Press the cover down.
6
Use a plastic spatula (or a screwdriver covered with tape) on the right of the rear window washer nozzle and carefully prise the brake light.
7
Repeat this operation on the left side.
8
Lift up the lamp and put out the electrical lead.
9
Replace the unit.
To fit
1
Put the electrical lead back again and put the lamp unit back.
2
Take the lead out on the inside of the cover.