saab Workshop Repair Guides

Saab Workshop Service and Repair Manuals

Bleeding the Hydraulic System|Page 1856 > < Bleeding the Hydraulic System
Page 2
background image

2.b. Remove the cover over the emergency valve and open the valve about a half turn.
2.c. Unlock the soft top from the windscreen frame.
2.d. Activate the fifth bow lock using the diagnostic tool set to UNLOCK and fold up the fifth bow.
2.e. Insert the wheel bolt tool through the opening in the right-hand luggage compartment trim and attach it in the drive mechanism link arm.
2.f. Unlock the soft top cover by pulling the tool backwards until the soft top cover lifts a few centimetres.
2.g. Remove the tool, close the boot lid and open the soft top cover.

3. Use a rag to protect the hose on the upper connection of the fifth bow cylinder on the left-hand side of the car.
4. Undo the upper connection on the fifth bow cylinder on the left-hand side of the car.

Does oil run from the hose?

JA
The hydraulic system is correct if there are no air bubbles. Connect the hose to the cylinder and make sure it is properly tightened. Continue with
step 11.

NO
The connection should be left open so that the hose end is visible for about 5 minutes (the system will slowly take in air). Then continue to step 5.

Bleeding the Hydraulic System|Page 1856 > < Bleeding the Hydraulic System