9-3 Viggen Coupe (9400) L4-2.3L Turbo (B235) HO (1999)
/l4-2.3l_turbo_(b235)_ho/Page-3215030.png)
Trip Computer Functions, SID 2
DIST (distance to destination)
The distance to destination is calculated using information on:
-
Odometer reading, unit km, miles (bus information from MIU).
The display range is 0 to 9999 km or miles. When the SID unit has been programmed with a value, a count-down begins using the actual distance
covered.
If no distance is given, the distance covered since the last SID unit reset will be shown. Resetting with CLR does not affect a programmed value for
distance to destination.
Calculations
The SID unit calculates the ration between DIST, ARRIV and SPD. To carry out these calculations, the value in DIST must be greater than 0.
If an arrival time is then programmed into ARRIV the SID unit will show the calculated average speed, or if a desired average speed is programmed in
SPD, the SID unit will show the estimated arrival time in ARRIV.
If the calculation is made when the car is running, the calculated value is replaced by the correct figure after 10 seconds. If the calculation is made with
the car stationary, the calculated value is replaced by the correct figure as soon as the car is driven.
ARRIV (Arrival Time)
The arrival time is calculated from information on:
-
Current time (internal SID function)
-
Programmed value in DIST.
-
Speed, unit km/h, mph (bus information from MIU).
The display range is from the present time and onwards up to 23 hours and 59 minutes, updated every second.
When DIST is 0, the current time will be displayed on the SID.
