9-3 Viggen Coupe (9400) L4-2.3L Turbo (B235) HO (1999)
Hose/Line HVAC: Service and Repair
Evaporator Low-Pressure Pipe
Removing
IMPORTANT
The evaporator low-pressure pipe must be cut when removing. The spare pant consists of a two-sectioned pipe.
1
Position the car on a lift.
2
Remove the grille.
3
Drain refrigerant from the A/C system, see Refrigerant, A/C/Service and Repair.
4
Remove the battery.
5
Remove the bolt in the console that secures the battery cable holder.
6
Remove the main fuse box.
7
Remove the compressor low-pressure pipe from the holder on the front cross member.
8
Remove the clip securing the low-pressure side service connection.
9
Remove the evaporator low-pressure pipe from the holder on the wheel housing.
IMPORTANT
Both the receiver and the compressor oil absorb moisture from the air that cannot be removed. All connections that are opened must be plugged
immediately.
10
Remove the nut that secures the evaporator low-pressure pipe to the service connection.