9-3 XWD (9440) L4-2.0L Turbo (B207R) (2009)
/l4-2.0l_turbo_(b207r)/Page-4153004.png)
10% Standard curing agent (suitable for paint), but not MS type.
5. Allow to dry and sand if required.
6. Shower carefully with the mixture. If a coarser structure is desired, lower the spray pressure and hold the spray gun at a greater distance. If a finer
structure is desired, increase the spray pressure and hold the gun closer.
7. Place the part in a paint oven at 60 degrees C, so that the structure sets.
Useful tips; The mixture can also be used to raise small plastic burrs on sanded surfaces. The part can be cured in an oven at 60 degrees C and then
rubbed with an abrasive cloth, Scotchbrite or the like.
Scuff Plate
Scuff Plate
To remove
1. Remove the scuff plate by using a removal tool to lift it up.
To fit
1. Fit by guiding in the clips and pressing them into the scuff plate.
