9-3 XWD (9440) L4-2.0L Turbo (B207R) (2009)
Rear Knuckle Alignment Link: Service and Repair
Toe-in link
To remove
1. Raise the car.
2. Remove the rear wheel.
3. Remove the wheel sensor connection to avoid damage to the wheel sensor.
4. Mark and remove the toe-in link adjusting screw.
5. Clean and lubricate the threads in the outer toe-in link retaining bolts.
Remove the nut holding the toe-in link to the steering swivel member. Hold with a 10 mm sleeve in the outer mounting.
6. Remove the toe-in link.
To fit
1. Put the toe-in link into place.