9-5 (9600) L4-2.3L Turbo (2007)
/l4-2.3l_turbo/Page-2466001.png)
Discharge Air Temperature Sensor / Switch: Service and Repair
Blended-Air Temperature Sensor, LH
Blended-Air Temperature Sensor, LH
To remove
1. Remove the data link connector, 2 screws, and detach the leads to the floor lighting.
2. Remove the lower part of the panel from the driver's side, 3 screws.
3. Pull the sensor (A) from the air duct, which leads to the lower part of the panel, by releasing the clips and sliding it out
4. Remove the radio section (A) and the ACC control panel (B).
