9-5 (9600) L4-2.3L Turbo (2.3 T) (2006)
Blower Motor Resistor: Service and Repair
Ventilation Fan Control
To remove
1. Drape protective covers over the front wings.
2. Remove the wiper arms with 85 80 144 Puller, windscreen wiper arm.
3. Remove the rubber seals on the wiper spindles.
4. Remove the rubber moulding along the edge of the bulkhead and loosen the clips on one side. Place the rubber moulding on one side.
5. Loosen the cover over the bulkhead partition space (fastened with clips) by lifting it carefully forwards so that it is released from the windscreen.
6. LHD: Move aside the bonnet cable and lift the cover backwards towards the windscreen.
NOTE: Take care when removing the clips.
7. Loosen the clips holding the front edge of the water shield with a screwdriver. Lift off the water shield.