9-5 (9600) L4-2.3L Turbo (2.3 T) (2006)
/l4-2.3l_turbo_(2.3_t)/Page-1856005.png)
4. Insert the lock plate. Check that the lock plate's 2 bearings (rubber bush and dome) in the housing are in place.
5. Snap the ignition switch pawl into the lock plate.
6. Put the lock plate bracket in place. Apply Loctite 242, part no. 74 96 268, to the bolts holding the lock plate bracket.
7. Fit the lock plate spring.
8. Adjust the position of the lock plate with the screw on the lock plate holder so that it is level with the lug in the gear lever housing.
IMPORTANT: The deflection limiter must not be in contact with the lock plate during adjustment.
9. Fit the complete gear lever housing and selector rod.
Gear Lever Knob Removal And Installation
Gear Lever Knob
To Remove
