saab Workshop Repair Guides

Saab Workshop Service and Repair Manuals

System Overview|Page 7551 > < System Overview|Page 7549
Page 46
background image

WASHER FLUID LEVEL LOW is shown after a 70 second delay and FILL COOLANT FLUID is shown after a 30 second delay (not when ignition
ON "CHECKING").

The driver acknowledges a message by pressing any button except NIGHT PANEL. If more than one message is activated, the next message is
acknowledged in the same way. When a message has been acknowledged, it is not shown again. If the messages are not acknowledged, they are deleted
from the display automatically at the rate of one message per minute.

Service Message

Service Message

General

SID 1 and 2 are equipped with a service indicator which shows the message "TIME FOR SERVICE" on the SID when it is time to service the car. The
time for this is controlled by the odometer which shows how far the car has travelled since the last service, and the day counter which calculates the
number of days since the last service.

The service interval is programmable and is programmed during production according to the various markets. If necessary, the interval can be changed
using the diagnostic tool.

Activation of the service message

The service message is shown when the day counter reaches 365 days or when 1000 km or 600 miles are left until the next service, whichever is the
sooner. The message is shown when the ignition is turned on and reads "CHECKING".

Manual reset

The service message is reset by pressing and holding the CLEAR button for at least 8 seconds. The SID gives two acoustic signals in quick succession.
On the second signal "SERVICE" starts to flash. Resetting means that the service interval is recalculated and the day counter zeroed.

Automatic reset

The service message is reset automatically when it has been activated (shown) on the display 20 times.

Reset with diagnostic tool

The service message can be reset using the diagnostic tool even if it has not been activated. This is useful if a service is carried out before a long journey
for example. The time to next service is then calculated starting from the current odometer reading. On resetting, the day counter is also zeroed at the

System Overview|Page 7551 > < System Overview|Page 7549