9-5 (9600) L4-2.3L Turbo (B235) (2001)
1. Make sure that the filter is clean and undamaged. Change O-ring and fit the glow plug holder with filter.
2. Refit the fork.
3. Change the O-ring and fit the glow plug.
4. Connect the cables to the glow plug and tighten the nut.
NOTE: Check that the insulation on the glow plug cables is undamaged.
5. Fit the flame temperature sensor.
6. Fit the flame temperature sensor's leads in connector B2.
NOTE: Pay attention to the location of the pins when fitting them in the connector.