9-5 Aero (9600) L4-2.3L Turbo (B235) HO (2000)
Onstar Component Replacement - 9-5 Sedan:
VIU/VCU
To remove:
1
Remove the 4 screws securing the bracket to the underside of the rear shelf.
2
Release the snap-locks for the VIU or VCU module to remove it from the bracket.
3
Release the connector housing from the module.
To fit:
1
Refit the new module(s) in reverse order. Take up the slack in the wiring harness and tuck it behind the carpet,
NOTE:
Before fitting the new module(s), the serial number (VCU) or station ID (VIU) must be recorded and provided to the OnStar Call Center, at
1-888-ONSTAR1, prompt 1.
2
Reset the OnStar system by pressing and holding the Call End (white dot) button on the OnStar three-but- ton assembly. The LED will be green,
turn red, then go back to green again.
3
Move the vehicle outside. Leave it running for ten minutes. Press the OnStar key and ask the advisor for a reconfiguration.
If you have trouble connecting to OnStar, configuring or activation on a Saab OnStar system, try the following:
^
Let the car run for 10 minutes, then press the blue OnStar Call Button. You should see the LED flashing green because a call is in progress.