9-5 Aero (9600) L4-2.3L Turbo (B235) HO (2000)
/l4-2.3l_turbo_(b235)_ho/Page-2626046.png)
^
Connect a jumper lead between B+ and pin A of the female connector.
^
The test lamp should light.
Test results OK?
YES
^
Go to point 2.
NO
^
Repair or replace the lead between pin A of the female connector and grounding point G2.
^
Go to point 4.
2. Check control module signal input
^
Connect the diagnostics tool to the vehicle and contact: SID.
^
Read status; washer fluid level sensor.
^
The tester should show status: OFF.
Test results OK?
YES
^
Go to point 3.
NO
^
Repair or replace the lead between pin B of the female connector and pin 6 of the control module.
^
Go to point 4.
3. Check the control module signal input (contd.)
^
Connect a jumper lead between pins A and B of the female connector.
