9-5 Aero (9600) L4-2.3L Turbo (B235) HO (2000)
^
Read status: washer fluid level sensor.
^
The tester should show status: ON.
Test results OK?
YES
^
Replace: Washer level switch.
^
Go to point 4.
NO
^
Repair or replace the lead between pin B of the female connector and pin 6 of the control module.
^
Go to point 4.
4. Final check
^
Clear the diagnostic trouble codes in all systems.
^
Carry out a function check.
Test results OK?
YES
^
The steps taken to rectify the fault were correct.
NO
^
See "Before changing a control module." See: Fault Diagnosis, General/Before Changing A Control Module