9-5 Arc Sport Wagon (9600) V6-3.0L Turbo (B308) (2002)
The TC/ABS control module sends a bus message "Wheel speed, right front, XXX km/h" via the P-bus to the Trionic control module connection 19 and
66. This speed signal is used to:
-
prevent adaptation of idle speed control when the car is moving.
-
on manual gearboxes, determine which gear is currently being used. This makes it possible to limit torque in gears R and 1 and activate fuel
shut-off in gears 2, 3, 4 and 5. Control of the SHIFT UP lamp also depends on the current gear.
-
activate speed limitation by limiting the maximum air mass/combustion at 240 km/h.
Diagnostics
-
If there is no speed signal, diagnostic trouble code P0502 will be generated.
-
If the speed value is implausible, diagnostic trouble code P0501 will be generated.
System reaction to a fault
-
The speed (bus from MIU) is used as a substitute value.