9-5 Arc Sport Wagon (9600) V6-3.0L Turbo (B308) (2002)
/v6-3.0l_turbo_(b308)/Page-1221002.png)
The crankshaft position sensor supplies pins 17 and 18 of the control module with information on crankshaft position and speed.
On the crankshaft is a slotted ring with 58 grooves. The sensor is an inductive type and is fitted in the wall of the engine crankcase. The distance between
the sensor and the slotted ring is between 0.4-1.3 mm and is not adjustable.
The sensor functions like a generator and delivers a sinus-wave alternating voltage. By measuring the frequency, the control module can determine the
engine speed. There are 2 ribs missing after the 58th one. When rib 1 then passes the sensor, the control module knows that the crankshaft is 117° before
top dead centre (BTDC).
The current produced by the crankshaft sensor varies with engine speed. At idling speed it is 5-10 V (AC) and at 2500 rpm about 15-20 V (AC).
However, it is the frequency and not the voltage that is of interest to the control module.
As soon as the control module receives pulses from the crankshaft sensor, it grounds the fuel pump relay.
The resistance of the sensor is 860 ± 90 ohms.
The engine speed is used for:
-
Indicating the engine operating point, in conjunction with the engine load. The operating point determines which values will be used in the
matrices and tables.
-
Regulating idling speed.
The crankshaft angle is used to calculate when angle-related functions should be activated, such as ignition, injection and knock detection.
Diagnostics
-
If the crankshaft position sensor is inoperative during starter motor cranking, diagnostic trouble code P0337 will be generated.
-
If the control module loses track of the crankshaft position while the engine is running, diagnostic trouble code P0336 will be generated.
