9-5 Arc Sport Wagon (9600) V6-3.0L Turbo (B308) (2002)
/v6-3.0l_turbo_(b308)/Page-1342006.png)
2. Connect the cable to the selector lever housing and fit the clamp.
3. Plug in the electrical connection to the ignition switch while putting the selector lever housing in place.
4. Refit the 2 cable ties for the wiring harness.
5. Push in the pin at the same time as the ball enters the end of the cable.
6. Fit the circlip and the anti-rattle clip.
7. Connect the air duct and tighten the selector lever housing.
8. Fit the center and floor console.
9. Adjust the position of the cable.
Selector Lever Casing
Selector Lever Casing
To Remove
