9-5 Linear (9600) L4-2.3L Turbo (2.3t) (2004)
/l4-2.3l_turbo_(2.3t)/Page-1548001.png)
Fuel Pressure Regulator: Service and Repair
Fuel Pressure Regulator
WARNING: Removal of the fuel pressure regulator involves partial dismantling of the car's fuel system. The following points must therefore
be observed in connection with this work:
^
Work only in a well-ventilated area! If approved equipment for the extraction of fuel vapour is available then make sure it is used.
^
Wear protective gloves! Prolonged contact with fuel can cause skin irritation.
^
Keep a class BE fire extinguisher close by! Be mindful of the danger of sparks caused by short circuits and when connecting and
disconnecting leads in electrical circuits.
^
Smoking is strictly forbidden.
^
Wear protective goggles.
To Remove
Important: Remove out fuse 19 while the engine is idling to minimize any remaining fuel pressure. Turn off the ignition when the engine has
stopped.
1. Unplug the connectors to the oxygen sensor and crankshaft position sensor.
2. Detach the vacuum hose.
3. Remove the bolt and open the clamp.
4. Gently work loose the pressure regulator.
To Fit
Fit in reverse order.
