9-5 Linear (9600) L4-2.3L Turbo (2.3t) (2004)
Electronic Brake Control Module: Testing and Inspection
ABS Without TCS or ESP
Test Readings, Control-Module Connections
Scope
The values and readings for measuring signals and levels in the ABS control module are given on the following pages.
Points To Remember:
-
Observe the test conditions. Use common sense in assessing the readings.
-
Start by checking that the control module is receiving power and is grounded.
-
Check all sensor inputs and signals from other systems.
-
Finally, check the control module outputs. Remember that the readings do not provide an indication that the actuator is operating.
-
If any reading is not OK, consult the wiring diagram to trace the leads, connectors or components that need further checking.
-
The specified readings are valid for a correctly calibrated Fluke 88/97.
-
The readings %(+) and ms(+) indicate the pulse ratio and pulse length. A test instrument capable of measuring both pulse ratio and pulse
length must be used. The '+' sign denotes a positive trigger pulse (TRIG+).