9-5 Linear Sport Wagon (9600) L4-2.3L Turbo (B235) (2002)
/l4-2.3l_turbo_(b235)/Page-2402003.png)
1. Attach the connector to the receiver unit. Turn the unit so that the connector points to the back of the car.
2. Fit the receiver unit in the cavity in the floor console's side wall.
3. Fit a clip on the LH and RH side wall of the floor console. If there had been a clip mounted on the LH side wall, fit the new clip 35 mm above the
previous location.
4. Place the wiring harness of the receiver unit in the clips and adjust their placement so that the wiring harness is run just under the lower edge of the
air duct opening.
NOTE: If necessary, the tape around the wiring harness must be removed enough to move the wiring harness branching sufficiently to fix the wiring
harness correctly. The wiring harness must also be adapted so that the rear portion of the floor console can be fitted without moving the harness from the
clips. Affix new tape around the wiring harness.
5. Attach the connector to the rear portion of the floor console.
6. Fit the rear portion of the floor console by fitting the lower journals into the holes and carefully pressing down the front edge so that the catch
fastens.
7. Lower the floor console's armrest.
