saab Workshop Repair Guides

Saab Workshop Service and Repair Manuals

A/T - Vibration/Noise Idling in 'DRIVE' Position|Page 9993 > < A/T - Vibration/Noise Idling in 'DRIVE' Position|Page 9991
Page 9
background image

15.

Remove the screw from the front bush on the right-hand side of the subframe.

16.

Check that the bush is correctly fitted. The bushes must be fitted with one opening to the front and one to the rear.

17.

Is the bush correctly fitted in the subframe?

NO: Replace the bush following "WIS - 7. Suspension, wheels - Suspension, front - Adjust, replace - Bush, subframe". Then continue following
step 18 of these instructions.

YES: Continue following step 18 of these instructions.

18.

Mark the position of the bush with a dash to check that it is not rotated when the screw is fitted.

19.

Place a 2 mm thick washer between the bush and the body if it can be done without forcing it in.

Note

A/T - Vibration/Noise Idling in 'DRIVE' Position|Page 9993 > < A/T - Vibration/Noise Idling in 'DRIVE' Position|Page 9991