9-5 Linear Sport Wagon (9600) L4-2.3L Turbo (B235) (2002)
6. Unplug the connectors for the injectors, ignition discharge module, absolute pressure sensor, mass air flow sensor and the turbo pressure sensor.
7. Slacken the upper bolt of the wiring holder.
8. Remove the lower screws.
9. Lift up the wiring holder and bend it rearwards.
10. Loosen the cable and bend them to one side.
IMPORTANT:
Secure each injector clip with a narrow cable tie. Make sure that it is fitted correctly before tightening. If not, the injectors could come loose from the
fuel rail during the flow test.
11. Undo the fuel lines with 83 95 261 Tools, Fuel line.
12. Clean the area round the injectors with compressed air.