9-5 Linear Sport Wagon (9600) L4-2.3L Turbo (B235) (2002)
/l4-2.3l_turbo_(b235)/Page-1003.png)
2. Remove the antenna unit for immobilization by turning it clockwise. Do not disconnect the switch. Place the antenna unit on the side of the
ignition switch.
NOTE: The antenna unit should be removed at low temperatures due to the risk of crack formation.
3. Hold the accompanying transponder over the hole in the antenna unit. Switch the ignition to the ON position. Hold the transponder in the same
position for a few seconds.
Once the transponder code has been read by TWICE, the alarm indicator diode will stop its double flashing. If the alarm indicator diode does not
stop its double flashing, repeat step 3. Adjust the position of the accompanying transponder.
4. Select body system and navigate to TWICE with the diagnostic tool. Do not press ENTER.
5. Hold the accompanying transponder above the hole in the antenna unit.
6. Press ENTER on the diagnostic tool.
7. Select Programming
8. Select Spare Part Programming
9. Perform spare part programming. Select the alternatives applicable to the car in question.
10. Upon completion of spare part programming, select "Programming of transponders and remote controls". Press ENTER. Press NO when asked
