saab Workshop Repair Guides

Saab Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 2549 > < Diagram Information and Instructions|Page 2547
Page 3
background image

-

37 A, high speed
When the conditions for high speed are fulfilled, low speed should be active for 2 seconds before high speed is activated. If high speed is active
and the conditions for stopping both low speed and high speed are fulfilled, high speed is stopped immediate and low speed is stopped after 2
seconds.

NOTE  High speed cannot be activated until 15 seconds after the ignition has been turned on.

Diagnostics 
If the coolant temperature lies outside the limits or if coolant temperature information is not given, the DICE starts low speed running after 5 seconds.
This prevents engine overheating.
A diagnostic trouble code is generated in Trionic, "Engine control system, Trionic V6", Fault diagnosis for further information.
The DICE receives information on the coolant temperature from TRIONIC.

The radiator fan is activated as follows:
1. Low speed

Activated when the coolant temperature reaches 97° C and stopped when the temperature drops to 93° C. 

2. High speed

Activated when the coolant temperature reaches 107'C and stopped when the temperature drops to 103'C.
When the A/C is requested, there are some conditions in DICE and in TRIONIC that must be fulfilled before the A/C compressor clutch is
engaged. For further information about the A/C and its control see Heating and Air Conditioning. For further information about the engine coolant
temperature sensor see "Engine control system, Trionic V6", Technical description, "Engine coolant temperature sensor" . When the A/C coupling
is active, the radiator fans are activated according to the following conditions:

1. Low speed

Activated when the outside temperature exceeds 22° C and stopped when the outside temperature falls below 20° C. 
Low speed
Vehicle speed is below 38 km/h while A/C pressure is between 9 and 18 bar.
Low speed running stops when vehicle speed rises above 40 km/h or A/C pressure drops below 7 bar.

3. High speed

A/C pressure is above 18 bar. 
High speed running stops when A/C pressure is below 14 bar. 
To understand the operation of the radiator fan, it is important to note that it can be activated differently at the same value (within certain preset
limits), depending on whether the value is rising or falling. If coolant temperature is 95° C, for instance, low speed will be activated if the
temperature was previously 97° C or above and has now fallen to 95° C. However, if low speed had not been activated and the coolant
temperature is 95° C, low speed will not be activated.

Operation with ignition OFF 

Diagram Information and Instructions|Page 2549 > < Diagram Information and Instructions|Page 2547