saab Workshop Repair Guides

Saab Workshop Service and Repair Manuals

Recall - ECM Replacement|Page 2879 > < Diagram Information and Instructions|Page 2870
Page 1
background image

Technical Service Bulletin # 248-2262

Date: 000901

Recall - ECM Replacement

CAMPAIGN INSTRUCTIONS

MI No. 248-2262 
PI No.

Date: September 2000 
Distr.: US, CA, JP

9-5

Recall 724: Replacing engine control module (ECM)

Background

The Trionic T7 engine control modules manufactured before December 6, 1999 have rubber supports for the circuit board that are faulty. These supports
contain substances that can accelerate oxidation, which in turn can lead to open circuits on the circuit board. This can produce symptoms such as starting
problems and the engine running unevenly. The CHECK ENGINE lamp may illuminate and the car may go into limp-home mode.

If Recall 719 has already been performed, please see this bulletin for additional work that must be performed. If Recall 719 has not been performed,
please see MI 291-2211, edition 3 for complete details on required work.

Symptom

Starting problems and engine running unevenly. CHECK ENGINE lamp may light

Cars affected

Saab 9-5 models within the following VIN Serial No. Ranges:

X3000001 - Y3046304

Owner Notification

As much as possible, owners of affected vehicles will be notified by Saab Cars USA, Inc.

There will be no VIN Status List issued for this campaign.

Please check your IRIS On-Line Recall & Service Campaign Inquiry for open campaigns.

Please note that vehicles in which a T7 ECM was replaced on a warranty claim with a repair date on or after March 1, 2000, regardless of the ECM part
number used, are considered to be completed under the terms of this Recall and will be marked as completed on the Recall and Service Campaign
Inquiry screen. No additional Recall 724 action is required for these vehicles. No owner notice will be sent to owners of these vehicles.

Material

53 80 712 T7 ECM for 1999 B235E up to VIN X3020000
53 80 704 T7 ECM for 1999 B235E above VIN X3020001
53 81 199 T7 ECM for 2000 B235E
53 81 165 T7 ECM for 2000 B235R
53 80 720 T7 ECM for 1999 B308E up to VIN X3020000
53 80 688 T7 ECM for 1999-2000 B308E from VIN X3020001 - Y3039999
53 81 025 T7 for 2000 B308E from Y3040000 - Y3046304

Parts equal to 25% of those vehicles wholesaled to your dealership will be shipped according to the schedule outlined in the IRIS Reference posted in the
IRIS Service and Warranty Reference Library on 2000/08/31. Additional parts should be ordered using normal ordering procedures.

Important

A special programming procedure is used when performing this Recall. You must use Tech 2 version 37.000 or a later version.

Tools

Numeral 8 punch: 02 97 713
This tool may be ordered directly from Kent-Moore at 1-800-345-2233.

Recall - ECM Replacement|Page 2879 > < Diagram Information and Instructions|Page 2870