9-5 SE Wagon (9600) V6-3.0L Turbo (B308) (2001)
Procedure
To remove, method A
1.
Turn the ignition switch to the ON position.
2.
Engage distribution mode VENT. Wait until the system has stabilized, (approx. 30 seconds).
3.
Turn the ignition key to the OFF position.
4.
Remove the heating and ventilation unit from the car, as described in WIS 9-5 M98 - 8. Body - Heating and ventilation, A/C -
Adjustment/Replacement - Climate control unit.
5.
Remove the foam seal from around the fan unit.
6.
Up to M04 inclusive: Remove the plate holding the connectors on the passenger side. For models with temperature sensor, remove the temperature
sensors connector from the plate. The connector's wiring harness enters the heating and ventilation unit via a rubber grommet.
Remove the fan control unit on the driver's side. For models with a transparent water barrier in front of the fan control module, this must be
removed first.